Arduino Uno R3 Development Board (Compatible board- High Quality)
₹650.00
(Excluding 18% GST)
Product Code: TAP_AU_328_C
Reward Points 1
Availability: Out Of Stock
OverView
Compatible Development Board Atmega 328P The Arduino Uno R3 is a development board based on the ATmega328 ."Uno" means one in Italian and...Product Description
Compatible Development Board Atmega 328P
The Arduino Uno R3 is a development board based on the ATmega328 ."Uno" means one in Italian and is named to mark the release of Arduino 1.0. It has 14 digital input/output pins , 6 analog inputs, a 16 MHz ceramic resonator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started. The Uno R3 differs from all preceding boards in that it does not use the FTDI USB-to-serial driver chip. Instead, it features the Atmega16U2Atmega8U2 up to version R2) programmed as a USB-to-serial converter. The Arduino UNO can be powered via the USB connection or with an external power supply. The power source is selected automatically. External (non-USB) power can come either from an AC-to-DC adapter (wall-wart) or battery. The adapter can be connected by plugging a 2.1mm center-positive plug into the board's power jack. Leads from a battery can be inserted in the Gnd and Vin pin headers of the POWER connector. The board can operate on an external supply of 6 to 20 volts. If supplied with less than 7V, however, the 5V pin may supply less than five volts and the board may be unstable. If using more than 12V, the voltage regulator may overheat and damage the board. The recommended range is 7 to 12 volts.
Technical Specification
Microcontroller | ATmega328 |
Operating Voltage | 5V |
Supply Voltage (recommended) | 7-12V |
Maximum supply voltage (not recommended) | 20V |
Digital I/O Pins | 14 (of which 6 provide PWM output) |
Analog Input Pins | 6 |
DC Current per I/O Pin | 40 mA |
DC Current for 3.3V Pin | 50 mA |
Flash Memory | 32 KB (ATmega328) of which 0.5 KB used by bootloader |
SRAM | 2 KB (ATmega328) |
EEPROM | 1 KB (ATmega328) |
Clock Speed | 16 MHz |
*Image shown is a representation only.
Related Products
Fire/Flame Sensor Module - Infrared Detection module (IR)
₹63.00 ₹100.00
Joystick Module - Dual Axis XY
₹43.00 ₹55.00
Laser Module 650NM 5V - (Compatible with Arduino)
₹45.00 ₹65.00
LilyPad Arduino 328 - ATmega328P Main Board 16M
₹235.00 ₹400.00