PIC18F252 Flash 28-pin 32kB 40MHz Microcontroller

PIC18F252 Flash 28-pin 32kB 40MHz Microcontroller
Product Code: MC_PIC18F252
Reward Points: 90
In Stock
International Shipping starts from 13 USD: DHL / Fedex (3-7 days priority delivery)

Price (Inclusive of Taxes): Rs.309.00
Price in reward points: 3000
Qty:  
   - OR -   

PIC18F252 Flash 28-pin 32kB 40MHz Microcontroller (Microchip)

 

Specifications
  • 28-pin Low Power Microcontroller
  • Flash Program Memory: 32 kbytes
  • EEPROM Data Memory: 256 bytes
  • SRAM Data Memory: 768 bytes
  • I/O Pins: 23
  • Timers: One 8-bit / Three 16-bit
  • A/D Converter: 10-bit Five Channel
  • PWM: 10-bit Two Modules
  • SSP: SPI and I²C Master/Slave Support
  • AUSART: Addressable Full Duplex Operation
  • External Oscillator: up to 40MHz

 

Feature
  • High-Performance RISC CPU
    • Source code compatiable with the PIC16 and PIC17 instruction sets
    • Linear program memory addressing to 32 Kbytes
    • DC - 40 MHz osc./clock input
    • 16-bit wide instructions, 8-bitwide data path
    • Priority levels for interrupts
    • 8 x 8 Single Cycle Hardware Multiplier
  • Peripheral Features
    • High current sink/source 25 mA/25 mA
    • Three external interrupt pins
    • Two 16-bit timer/counter (TMR1, TMR3)
    • One 8-bit/16-bit timer/counter with prescaler
    • One 8-bit timer/counter with 8-bit period register
    • Capture 16-bit, max. resolution 6.25 ns.(TCY/16)
    • Compare 16-bit, max. resolution 100 ns.
    • 3-wire SPI (supports all 4 SPI modes)
    • I ²C Master and Slave mode
    • Supports RS-485 and RS-232
    • Parallel Slave Port (PSP) module
  • Special Microcontroller Features
    • Power-On Reset
    • Power-up Timer (PWRT) and Oscillator Start-Up Timer (OST)
    • Power-On Reset
    • 100,000 erase/write cycle Enhanced FLASH program memory typical
    • 1,000,000 erase/write cycle Data EEPROM memory
    • Self-reprogrammable under software control
    • Watchdog Timer (WDT) with its own On-Chip RC oscillator
    • Programmable code protection
    • Power saving SLEEP mode
    • 4X Phase Lock Loop (of primary oscillator)
    • Secondary Oscillator (32kHz) clock input
    • Single supply 5V In-circuit Serial Programming via two pins
    • In-Circuit Debug (ICD
  • Analog Features
    • Compatiable 10-bit Analog-to-Digital Converter module (A/D)
    • Programmable Low Voltage Detection (PLVD)
    • Programmable Brown-out Reset(BOR)
  • CMOS Technology
    • Low power, high speed FLSH/EEPROM technology
    • Fully static design
    • Wide operating voltage range (2.0V to 5.5V)
    • Industrial and Extended temperature ranges
    • < 1.6 mA typical @ 5V, 4 MHz

*Image shown is a representation only.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: